teddis
Fractal Fanatic
Hi guys,
I thought I might start a new thread pertaining to the use of the Evm ( CAB ON ) and the Matrix amp. I have only ever used my Evm's with CABS off . Since I just received my Matrix amp I thought I would back up my banks, save my special patches, and reload Factory banks.
Results, for sure my heavy stuff is improved, recto really nice. Cleans nice too. I have a couple of questions for the full range users of the EVM if I may. I know there are a few of you out there
I should say my ultimate goal is FR through the EVMs through OP2 , OP 1 to the board (stereo)
I am only using factory IRs as I have not figured out how to load own hammers yet.
1) Did you roll of any freq, like the 63k like Paul M does globally ?
2) If you hear any darkness...... Muddiness, flubiness, how did you address this ? Within the patch ? Cabs, or
globalEQ ?
Thx !
I thought I might start a new thread pertaining to the use of the Evm ( CAB ON ) and the Matrix amp. I have only ever used my Evm's with CABS off . Since I just received my Matrix amp I thought I would back up my banks, save my special patches, and reload Factory banks.
Results, for sure my heavy stuff is improved, recto really nice. Cleans nice too. I have a couple of questions for the full range users of the EVM if I may. I know there are a few of you out there
I should say my ultimate goal is FR through the EVMs through OP2 , OP 1 to the board (stereo)
I am only using factory IRs as I have not figured out how to load own hammers yet.
1) Did you roll of any freq, like the 63k like Paul M does globally ?
2) If you hear any darkness...... Muddiness, flubiness, how did you address this ? Within the patch ? Cabs, or
globalEQ ?
Thx !