fizzoftheburn
Member
Quick explanation of my setup. I plug directly into my axe. Output 1 XLR L&R go to monitors and FOH with cab sims on. Then output 2 L&R (sans cab sims) are sent out to a Matrix G1600. Then finally output A is sent to a Mesa Rectifier 4x12. Output B to a Mesa Lonestar 2x12. All my live patches use 2 amps, panned hard L&R to send each amp separately to the different cabinets. I think that's the skinny of it.
I use 3 basic patches with all amps saved as global amps. High gain, crunch, and a pristine clean. From there I've created about 25 odd patches based off of those main tones.
My issue is the level of my clean patches have significantly and mysteriously dropped much lower then the levels of my high gain and crunch patches. My FOH has claimed not to be experiencing this issue. So it may just be what's routed to output 2. A quick look at the patches amp & cab levels don't reveal any change as to what I started the tour with.
Is my next course of action to reset the axe and reinstall firmware and patches??
Thanks in advance for any help with the issue.
I use 3 basic patches with all amps saved as global amps. High gain, crunch, and a pristine clean. From there I've created about 25 odd patches based off of those main tones.
My issue is the level of my clean patches have significantly and mysteriously dropped much lower then the levels of my high gain and crunch patches. My FOH has claimed not to be experiencing this issue. So it may just be what's routed to output 2. A quick look at the patches amp & cab levels don't reveal any change as to what I started the tour with.
Is my next course of action to reset the axe and reinstall firmware and patches??
Thanks in advance for any help with the issue.