Delay effect's "Spread" parameter?

P

peerhan

Member
Hi all,

I was dialing in some tones on my Standard today, and while I was tweaking the delay I became confused about the "Spread" parameter.

Why does it go from -100% to 100%? It would seem that 0% is mono, and 100% is full separation stereo. What is -100%? Does it flip the L & R channel feedback settings?

thanks,

Peerhan
 
AFAIK,

-100% is full Left, 0% = Center and 100% is full Right.

Per manual:

SPREAD - Controls the stereo spread of the echoes. Increasing this value increases the separation between the left and right delay signals.
Click to expand...
 
Nothing to do with feedback specifically, just where each delay output is panned. At -100% the "left" delay is completely in the right channel and vice versa.
 
You must log in or register to reply here.
Back
Top Bottom