GuitarMan86
Power User
Just noticing.....not a crisis situation (note: this does NOT occur if AE 3.0 window is closed and USB still connected)
If you are using AE 3.0 and change to a different preset using the front panel, or the MFC, or AE window.....the AE front panel ends up defaulting to the EDIT screen of a block (or whatver block you had been on).
If you use the MFC and change presets....it changes and then goes right back to the EDIT screen of a block. Same if using the front panel value knob etc.?
Hoping this isnt correct behavior as....if I am using my MFC on the floor and switch presets I prefer to see the preset screen....and not simply some edit screen of a block. Close AE window....and works fine again.
Anyone?
If you are using AE 3.0 and change to a different preset using the front panel, or the MFC, or AE window.....the AE front panel ends up defaulting to the EDIT screen of a block (or whatver block you had been on).
If you use the MFC and change presets....it changes and then goes right back to the EDIT screen of a block. Same if using the front panel value knob etc.?
Hoping this isnt correct behavior as....if I am using my MFC on the floor and switch presets I prefer to see the preset screen....and not simply some edit screen of a block. Close AE window....and works fine again.
Anyone?