Seems Yek is always doing something cool.
I'll research w/d/w rig stuff and how to implement it with an Axe FX III. I have much to learn.
Here is what the grid would look like for a simple W/D/W set up. Out 1 would have the effects and go to the split wide monitors. Out 2 would go to the center Dry monitors with just amp and cab signal. In a traditional W/D/W rig, the effects signal would be 100% wet, with no dry signal to Out 1, but I think it sounds better with some dry signal mixed in there as well. You'll have to experiment and see what you like. Also, just FYI, if Out 2 would be going to a traditional power amp and guitar cab, you would split off of the main signal earlier, before the cab block. Good Luck!
View attachment 71733
Here is what the grid would look like for a simple W/D/W set up. Out 1 would have the effects and go to the split wide monitors. Out 2 would go to the center Dry monitors with just amp and cab signal. In a traditional W/D/W rig, the effects signal would be 100% wet, with no dry signal to Out 1, but I think it sounds better with some dry signal mixed in there as well. You'll have to experiment and see what you like. Also, just FYI, if Out 2 would be going to a traditional power amp and guitar cab, you would split off of the main signal earlier, before the cab block. Good Luck!
View attachment 71733
yesSo, any of my favorite presets could be altered/rerouted in this manner, correct?
Absolutely!So, any of my favorite presets could be altered/rerouted in this manner, correct?
For a rotational delay, try incremental tempo for each speaker.
1R = t ms,
1L = t+x ms
2R = t+2x ms
2L = t+3x ms
If you gradually reduce x on each turn, you'll feel like in the vortex
Here you go, put this in your 4-monitor pipe and smoke it!
For this one, put Out1 through a stereo pair of monitors over to your right, and Out2 through a stereo pair on your left side......and rock out!!!
This was saved with FW 13.02, so if you don't have it you might have to wait till it's back out.