Mark Cullen
Inspired
After I updated to 1.06 the Axe-Fx does not complete it's start-up cycle.
It stops at "Initializing GUI": right before the Graphic progress bar screen...
right before the Graphic progress bar screen...
When I disconnect the FC-12 it completes the start-up and I can reconnect the FC-12 and everything is good.
Anyone know why this might be happening?
It stops at "Initializing GUI": right before the Graphic progress bar screen...
right before the Graphic progress bar screen...
When I disconnect the FC-12 it completes the start-up and I can reconnect the FC-12 and everything is good.
Anyone know why this might be happening?