I was prepping for digging into the changes from the past few firmware updates when I noticed something odd with the graphic on the 'Speaker' tab of the Amp blocks on the editor and the hardware between the Axe-Fx III and the FM9.
- Updated to the latest firmware versions on both units. (20.04 and 3.00)
- Set the 'Update Pre 20.02 (2.xx FM9) Presets Spkr Imp Upon Load' to 'Yes' on both units. And power cycled to make sure.
- Loaded a fresh amp block on an Empty preset.
- Tried a few different curves, same issue.
- All parameter values are the same between the two units.
- It looks a bit different than the FM9 with the exact settings.
- The peaks in the graphic don't match the parameter values.
- The graph tapers off on the high-end on the FM9, but not the Axe-Fx III?
- Is this just a UI difference?
- See screenshot for reference.