Axe-Fx III Firmware 32.01 Release

Not bashing computers but I have another running similar windows 11, I9, not as much ram and other good stuff. BUT it is running on that computer. I backed the unit up on that computer because some presets are unique to my bands set. I have tried using Microsoft troubleshooting. That has not worked either. I do note that it did suggest another computer. The 1st computer does work with another app in the same usb port. Also suggested as a test.
 
Interesting. I’m sure you’d prefer to have it working on the other computer, but matbe you can at least use this second computer when adjusting presets, at home??
Good luck
Lee
 
-Gen 4 hardware.
-Include plugin control (no processing) from ICONS framework.
-ADAT I/O

Cheque's in the mail.

(extremely bummed for Fractal... particularly Cliff)
 
Doc Rock said:
That would most likely have been "Efudex". It contains 5-fluorouracil, a commonly-used topical chemo agent. Makes the skin very red, and the out layer peels off, including any pre-malignant, or even early malignant, cells.
Click to expand...
Ah, yes... That was definitely what it was.
 
KFF said:
-Gen 4 hardware.
-Include plugin control (no processing) from ICONS framework.
-ADAT I/O

Cheque's in the mail.

(extremely bummed for Fractal... particularly Cliff)
Click to expand...
Are You Ok Whats Good GIF by The Resident on FOX
 
sprint said:
Cool feature 👍 - wrt outboard gear: wondering if it would have enough range (64 samples = -1.3ms ?) to line up a looped external effect? (Lets say 3-4ms for an external digital pedal incl Axfx loop da/ad conv).
Click to expand...
There are 4 mixer blocks - can you stack them for a total of 5.2ms, or does it not work like that?
 
FractalAudio said:
You could do that.

I can increase the max delay time. Trivial.
Click to expand...
Awesome - not sure if I'd ever need to go that high but nice to know we can!

I see the calculation explained in the block - not sure where to start other than twistin' and listenin'... in my case, Out 4 to Roland GP-100 back in in 2... (@Admin M@ wink, wink) is there a way to get a starting point based on outboard gear specs?
 
lair said:
Awesome - not sure if I'd ever need to go that high but nice to know we can!

I see the calculation explained in the block - not sure where to start other than twistin' and listenin'... in my case, Out 4 to Roland GP-100 back in in 2... (@Admin M@ wink, wink) is there a way to get a starting point based on outboard gear specs?
Click to expand...
You'd need to know the latency of the outboard gear. What I do is generate a sine wave with the Synth block, flip the polarity into the outboard gear and adjust the delay until they cancel out.
 
FractalAudio said:
You'd need to know the latency of the outboard gear. What I do is generate a sine wave with the Synth block, flip the polarity into the outboard gear and adjust the delay until they cancel out.
Click to expand...
Just to say what you already know, care would be needed to avoid being off by one or more whole sine wave cycles.
 
You must log in or register to reply here.
Back
Top Bottom