Planta Fantasma
Inspired
Thirmware Thursday?
Nice!
Nice!
If you create a new preset the new default values should load though.It’s a soft reset of these 2 base models. Not all amps.
Hiwatt's never did.The hiwatt modeled by Fractal doesn't have a CF apparently
Well, it has one but it's used in a peculiar wayHiwatt's never did.
What great site, thanks, didn't know about it. I haven't done any hardware electronics in a long time, but if I was headed that way, it'd be a wonderful resource.Well, it has one but it's used in a peculiar way
https://www.ampbooks.com/mobile/classic-circuits/hiwatt-phase-inverter/
Well, it has one but it's used in a peculiar way
https://www.ampbooks.com/mobile/classic-circuits/hiwatt-phase-inverter/
+1 - Not sure also how that one got by me. Awesome site for someone like me wanting to understand more for application to modelling but not really into physical amp building.What great site, thanks, didn't know about it. I haven't done any hardware electronics in a long time, but if I was headed that way, it'd be a wonderful resource.
This isn't a cathode follower in the classic sense. It's being used as a voltage regulator to supply a low impedance DC bias voltage to the PI. It's not in the signal path.Well, it has one but it's used in a peculiar way
https://www.ampbooks.com/mobile/classic-circuits/hiwatt-phase-inverter/
That's used to create a fixed bias voltage for the phase inverter.Well, it has one but it's used in a peculiar way
https://www.ampbooks.com/mobile/classic-circuits/hiwatt-phase-inverter/
This isn't a cathode follower in the classic sense. It's being used as a voltage regulator to supply a low impedance DC bias voltage to the PI. It's not in the signal path.
Yep, that's pretty much what that article says as wellThat's used to create a fixed bias voltage for the phase inverter.
So it's not a signal amplification stage.
Edit: I see Fractal beat me to it.
Just to add that tube is not being configured as a cathode follower. A cathode follower is an amplification stage that has a low output impedance and a gain of 1.
In the Hiwatt circuit they are using half of a 12ax7 to create a (DC) bias voltage. The only thing these have in common is they are taping off the cathode side of the tube.
Sending this to Dave Murray« Six, six six ! The number of the Cliff ! «
Someone check on Mud, make sure he didn’t faint! Kudos!Sending this to Dave Murray
If you do this …Sending this to Dave Murray
Confirmed here as well. Rolled back to 25.03 as I use an external switch to access the presets layout.Thank you for this update, just updated (after backing up). I think I've found a bug on the stand-in switches:
I have 4 external buttons (Mosky Dual Switches) that I have setup as follows in the pics below. The HOLD functions still work, but the TAP functions no longer work after the update. I have checked my FC Controller settings (which don't change) and they still seem set up properly from inception. Pls advise?
I've attached my system backup too.