Cpt737
Member
Guys I need an advice with a little experiment setup with my friend’s kemper stage he brought.
We are trying to use the kemper in a signal chain instead of amp and cab block on axe fx III. So;
Guitar -> Axe Input 1 -> axe pre amp effects(drive and phaser blocks) -> axe output3 -> kemper instr. input -> Kemper main output (stereo or mono?) -> Axe Input 3 -> Stereo effect block (ping pong delay etc.) and eq block-> axe output1 (stereo)-> Audio Interface -> Studio Monitors
We are confused about when to use stereo cables and when not?
Should we use the effects loop of kemper stage like a 4cm instead of this signal chain? Better solution?
What setting should we on Axe fx regarding output signals and routing?
Do you think in this setup there are so many A/D and D/A conversions that we might suffer from latency when playing?
Thank you have a great day
We are trying to use the kemper in a signal chain instead of amp and cab block on axe fx III. So;
Guitar -> Axe Input 1 -> axe pre amp effects(drive and phaser blocks) -> axe output3 -> kemper instr. input -> Kemper main output (stereo or mono?) -> Axe Input 3 -> Stereo effect block (ping pong delay etc.) and eq block-> axe output1 (stereo)-> Audio Interface -> Studio Monitors
We are confused about when to use stereo cables and when not?
Should we use the effects loop of kemper stage like a 4cm instead of this signal chain? Better solution?
What setting should we on Axe fx regarding output signals and routing?
Do you think in this setup there are so many A/D and D/A conversions that we might suffer from latency when playing?
Thank you have a great day