All Sanity Lost Freddy
Member
I'm looking to create a new pitch for my dirty channel and found that using a filter to fine tune my high pass and low cuts while using an enhancer, it gives me the control I'm seeking. However, I'm not sure where to place them.
Here is my set up in my Chain as we speak:
Intelligent Gate-----Compressor-----Drive------Gate/expander---GEQ, and last that feeds two amps and Cabs (the second amp and cab are obviously on a second block tied into the input)
Should I place a filter with an enhancer after the cabs (right sde ) or should I place it before it on the left side?
Please help, and all replies are much apprecated.
Here is my set up in my Chain as we speak:
Intelligent Gate-----Compressor-----Drive------Gate/expander---GEQ, and last that feeds two amps and Cabs (the second amp and cab are obviously on a second block tied into the input)
Should I place a filter with an enhancer after the cabs (right sde ) or should I place it before it on the left side?
Please help, and all replies are much apprecated.