fcb 1010 foot controller behringer

  1. L

    Behringer FCB 1010 Not resetting!!! Help PLEASE!!!

    I just bought a used FCB 1010 from reverb, when I try to factory reset it with foot switches 1 and 6, it just starts up as usual where it displays E5 then EP then 3.1 can someone help me understand these? After that start up it sits at "EF" and all the pedals are flashing. I'm not sure if there...
    • Lincoln
    • Thread
    • behringer factory reset fcb 1010 foot controller behringer foot contoller help reset
    • Replies: 7
    • Forum: Other MIDI Controllers
  2. T

    Help resetting my FCB

    Ive been trying to set up my fcb to run for my axe fx ultra, I wanted one whammy, one volume and the rest to just toggle through sounds. I've tried resetting it but it does not work. I've tried holding pedal one and three for five seconds on start up, nothing happens. I've done the same but with...
    • Thomas Haley
    • Thread
    • axe fx axe fx 3 axe fx ultra axefx 2 fcb 1010 foot controller behringer fcb1010 fcb1010 expression pedal
    • Replies: 1
    • Forum: Other MIDI Controllers
  3. T

    Axe fx ultra fcb

    Hey guys just wondering, I recently bought an ultra and fcb1010 and wondered, how do you set up the axe fx ultra to use both the expression pedals on the fcb1010 (no modifications)? I want one pedal for volume and one for whammy. Also how do I set the axe fx patches to each of the numbered foot...
    • Thomas Haley
    • Thread
    • axe fx axe fx ultra expression pedals fcb 1010 foot controller behringer fcb1010 fcb1010 expression pedal midi foot controller
    • Replies: 0
    • Forum: Rigs and Routing
  4. L

    FCB1010 sometimes not communicating with AxeFX II XL+

    How's it going! I couldn't find an answer anywhere so I decided to reach out since I'm very clueless. I own an Axe FX XL II and a FCB1010 loaded with the Eureka PROM, running them w two MIDI cables. They used to work great together but lately I've been running into an issue where the board...
  5. E

    Behring FCB 1010

    Hi there, I bought a behanger fcb1010, programmed an expression pedal and that worked for me. But the day after I turned on the foot controller and the led lights keep blinking. It doesn't startup anymore, can't reset it to the factory settings, can 't select banks on my rig anymore...Anyone who...
Back
Top Bottom