GrooveSync
New Member
Hi I have just changed my wiring in the studio so that i can utilise both output 1 (with Cab Emulation) and Output 2 (Matrix GT1000FX to MArshall 4x12 Cab) without rewiring, however when i turn on the Matrix i get a lot of clicks and pops come through the 4x12 cab. I also get a enormous amount of digital noise when turning the AxeFX front panel Output 2 control. I don't get any of this noise when connecting to the Output 1 jacks.
I am using hum buster leads (TRS to TS) to connect output 2 to the Amp.
I have disconnected all other connections (USB, Output 1, AES-EBU,MFC101) but this makes no difference. I have also tried different cables.
Has anyone else experienced this noise through output 2? Is the unit faulty?
I am on firmware version 7.00
Hope someone can help as it is unusable as it is.
Brett.
I am using hum buster leads (TRS to TS) to connect output 2 to the Amp.
I have disconnected all other connections (USB, Output 1, AES-EBU,MFC101) but this makes no difference. I have also tried different cables.
Has anyone else experienced this noise through output 2? Is the unit faulty?
I am on firmware version 7.00
Hope someone can help as it is unusable as it is.
Brett.