Joshua Benton
Member
Good evening tonemasters,
I have run into a new issue and cannot tell if it is hardware or software related.
For as long as I remember, whenever I have paired my Kali Audio LP6's (set to +4dB) with my Axe FX3 Mk2 Turbo, I have always gotten more than enough volume. For reference, a clean DC30 amp (master level -5db), with IRs at 0dB and the output level set to 0dB (Output one set to +4dB in internal settings), I can absolute fill my small bedroom when the output 1 knob is around 1 o'clock.
Now, all of a sudden, I can barely get levels that go above the sound of strumming with the same exact settings as above. I have dimed the knob, even pushed the output level to 10dB, and still i am not getting the same volume I was getting yesterday.
To my knowledge nothing has changed. I am running the most recent firmware, I am playing the same preset (but the issue affects all presets I believe).
Any advice on this would be appreciated.
I have run into a new issue and cannot tell if it is hardware or software related.
For as long as I remember, whenever I have paired my Kali Audio LP6's (set to +4dB) with my Axe FX3 Mk2 Turbo, I have always gotten more than enough volume. For reference, a clean DC30 amp (master level -5db), with IRs at 0dB and the output level set to 0dB (Output one set to +4dB in internal settings), I can absolute fill my small bedroom when the output 1 knob is around 1 o'clock.
Now, all of a sudden, I can barely get levels that go above the sound of strumming with the same exact settings as above. I have dimed the knob, even pushed the output level to 10dB, and still i am not getting the same volume I was getting yesterday.
To my knowledge nothing has changed. I am running the most recent firmware, I am playing the same preset (but the issue affects all presets I believe).
Any advice on this would be appreciated.