Axe-Fx Firmware Version 21.00 Release Candidate (Beta 7)

Status
Not open for further replies.
astrolux said:
I'm still having some wild volume drops when loading amps from block library. Only fixable by resetting the channel, which undoes all other settings. Subsequent attempts to load amps from block library leads to same thing. Only happens with SOME saved blocks.

Just a me problem?
Click to expand...

On most of my presets I had neg FB very high but that parameter got reset to new defaults in the update and that also made the volume drop. That could also be the case in your saved blocks?

Before simply turning neg FB up again, I tried to turn the channels volume up instead which often showed that I can leave neg FB on defaults now.

With these library saved blocks I'd try to turn up the volume first and listen if that sounds good and resave them in the library.
 
I really loved the low end response in 20.04 with my matrix power amp and mesa 4x12. Something is missing with Beta 7. I switched back to 20.04 and there it is again. What would be the effective parameter?
 
Last edited:
Cpt737 said:
I really loved the low end response in 20.04 beta with my matrix power amp and mesa 4x12. Something is missing with Beta 7. I switched back to 20.04 and there it is again. What would be the effective parameter?
Click to expand...
You'll find your answer if you read back through the thread
 
  • Wow
Reactions: J.C
Cpt737 said:
I really loved the low end response in 20.04 beta with my matrix power amp and mesa 4x12. Something is missing with Beta 7. I switched back to 20.04 and there it is again. What would be the effective parameter?
Click to expand...
Speaker Drive 50% + or -
 
nah, the low end is different because cygnus x-2 calculates the circuit differently and not because of speaker drive

i'd maybe try a lower transformer lf value in the amp block speaker tab, lowering the low cut input eq, adding a dynamic distortion block set to bass boost, or some combination of all three
 
chkayleebear said:
nah, the low end is different because cygnus x-2 calculates the circuit differently and not because of speaker drive

i'd maybe try a lower transformer lf value in the amp block speaker tab, lowering the low cut input eq, adding a dynamic distortion block set to bass boost, or some combination of all three
Click to expand...
It was about the difference between Beta 4 and Beta 7 low end.
 
BornIntoAttitude said:
Diezel VH4 silver models 2 and 3 seem to be switched. Channel 3 has a bright switch on the mode while only channels 1 and 2 have it on the real amp.
Click to expand...
If you are using Axe edit and it appears there is an error there that would make some sense so you load Dizzy silver 3 or think you are and it actually silver 2 ,
If you load the Dizzy Silver 3 just from the front panel in a new preset does it sound different than loading it from the amp list in Edit ?
 
Status
Not open for further replies.
Back
Top Bottom