TG3K
Fractal Fanatic
Ran into an issue last night that I've not seen before. I upgraded to FW 5.08 (from 5.05) a day or two after it was released, and used FracTool to batch update all the amp blocks on my personal presets. (I had also set FracTool to not change the basic tone, gain, and level settings.) Last night I finally went through the presets and found in about half of them, the amp block had been bypassed. I didn't see a pattern to indicate it was only on certain amp blocks; it seemed random. To add to the mystery, I could not un-bypass the amp blocks in Axe-Edit (running the most recent version) with either the Space bar on my keyboard or by double-clicking on the block. I could only do it by clicking the Bypass button on the bottom right corner of the Axe-Edit window.
I'm not sure if this was a FracTool issue, or something to do with the update. I just wanted to see if anyone else had seen a similar behavior where the Space bar or a double click would not un-bypass a block in Axe-Edit.
As a side note, I've decided that telling FracTool to ignore the tone and gain settings was not a good idea, since I'm still going to have to go through each preset to re-tweak things due to amp block changes/improvements.
I'm not sure if this was a FracTool issue, or something to do with the update. I just wanted to see if anyone else had seen a similar behavior where the Space bar or a double click would not un-bypass a block in Axe-Edit.
As a side note, I've decided that telling FracTool to ignore the tone and gain settings was not a good idea, since I'm still going to have to go through each preset to re-tweak things due to amp block changes/improvements.