Lkdog
Power User
Am trying out my AXE FX II XL as an effects unit for my CA Triptik head.
Want to use the 4CM discussed here. Created a preset and it works fine, but is noisy.
I grabbed a couple TRS to TRS cables and need to turn one end of each of them to a TS connection to make humbuster cables so it si a TRS to TS cable. Well- you guys know all of this....
Can I just desolder the Ring wire on the TRS connector, or do I need to solder it to the Shield?
Or is it easier to make a little jumper wire from the Ring connector end on the plug to the Shield?
Thanks for any input.
Want to use the 4CM discussed here. Created a preset and it works fine, but is noisy.
I grabbed a couple TRS to TRS cables and need to turn one end of each of them to a TS connection to make humbuster cables so it si a TRS to TS cable. Well- you guys know all of this....
Can I just desolder the Ring wire on the TRS connector, or do I need to solder it to the Shield?
Or is it easier to make a little jumper wire from the Ring connector end on the plug to the Shield?
Thanks for any input.