• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

Would anyone happen to know where the reverb tank in a Supro is in the circuit?

Gene

Inspired
Hi, would any of you happen to know where in a Supro amp is the reverb in the circuit?. Is it before the preamp section or between the pre and power amp?

I'm making a preset based around the supro model. Depending where it is in the circuit should I run direct into it in series before or after the amp block or create a parallel block in the grid for the spring reverb and join it back with the amp blocks output feed in the grid and on into the cab?.

I can't actually insert it between the preamp and poweramp circuits in the amp block. What is the best solution? Thanks :)
 

bondsong

Inspired
The Supro that's modelled in the AxeFx doesn't have a reverb tank as far as i can tell. Which model of Supro are you trying to emulate?
 

Gene

Inspired
Trying to base it on the new Comet one but with 12" or a 15" speaker. The Comet has reverb and Tube trem. The Comet's tremolo effect occurs in the preamp, before the reverb according to what I have read. I know there is no comet model in the amp list but the Supro one we do have is a good vintage one anyway so will sound good.
 

barhrecords

Axe-Master
Hi, would any of you happen to know where in a Supro amp is the reverb in the circuit?. Is it before the preamp section or between the pre and power amp?

I'm making a preset based around the supro model. Depending where it is in the circuit should I run direct into it in series before or after the amp block or create a parallel block in the grid for the spring reverb and join it back with the amp blocks output feed in the grid and on into the cab?.

I can't actually insert it between the preamp and poweramp circuits in the amp block. What is the best solution? Thanks :)
This is a good resource for schematics http://bmamps.com/Tech_sch.html
 

Gene

Inspired
Oh, thanks.......... I will have a look. I have the preset sounding pretty good using closed back studio headphones here (it's 22:37). I put the reverb in parallel to the amp block and joined it up pre and post cab sim. Sounds best at all volume changes on the guitar knob this way for some reason. Will check it through a FRFR cab tomorrow.
 
Top Bottom