Which amp is clipping?

[Ron_R]

I'm blowing through all of my user presets (most of which I got from AxeChange or on these forums) and some of them have two amps running in parallel. Some of those presets are clipping pretty bad and I'm trying to adjust them to remove the clipping but on the presets that have the two amps, how do I figure out which one is causing the *most* clipping?

I'm trying to limit how much tweaking is needed to eliminate the clipping, but find I'm just reducing them both until the clipping doesn't occur anymore. Is there a better way?

Btw, this FW is AMAZING. I've junked some of my older presets and am going to start some again from scratch just to "play". I'm amazingly impressed, AGAIN!

Thanks for any suggestions and thanks Cliff for the most amazing piece of guitar hardware there ever was (imho :mrgreen)

 

[Cooper Carter]

Reset them both. Drop them both by 10dB and work your way back up.

 

[ChrisCG]

^^^^^ this right here that is exactly what I did and it worked perfect.

 

[Rex]

To find out what levels your amps are at, mute one of them, and then check the level of the other one on the VU meter.

 

[Ron_R]

Thanks all!