In another thread RandyVanMartini said: ...you might as well go whole hog and go for a w\d\w set up....nothing sounds quite the same! You send a dry amp signal through the matrix and out to your 4x12 for the center dry channel, and then all you need is a quality pair of powered frfr speakers for your left and right wet channels. This kind of set up sounds HUGE, and is loads of fun to play through! I have a gt1000fx myself going through a 4x12, along with a pair of clrs for the frfr, and I can’t imagine playing through anything else, really.
Since that thread was moved to the Amps and Cabs section I wanted to ask these questions here:
Since that thread was moved to the Amps and Cabs section I wanted to ask these questions here:
- Can anyone describe the layout used to create this? I currently have a WDW rig running a Friedman BE100/Matrix 1000, but am on the waitlist for the III (3/10). I am considering all of the possibilities.....
- Would you use an amp block with no IR direct to the Matrix for this type of setup?
- Can the AxeIII mix any of the dry signal in with the wet cabs?
- Does the AxeIII act in any way as a mixer? I currently use a Mark L DSLM for this function.