Big Joe Daddy
Experienced
FIXED! Thanks GM and Chris.
I'm in the process of updating my presets to Quantum v1.01. I've got one preset with the Shiver Clean amp that works fine until I engage the wah block. To start with, I've got the amp settings on the patch tipping the output meters at about 0.0 dB. But when I engage the wah block, the higher frequencies send it off the chart into clipping territory. The level on the wah block is at 0.0 dB. When I listen to the preset through my monitors, I don't hear any significant volume difference with the wah block engaged or not. I've tried dialing back the 'Frequency Max' setting in the wah block. It helps a little but loses its tone when adjusting it enough to help with the clipping. Presently I'm using the 'Clyde' model but I've tried all the others with similar results. I used this same setup in my patches prior to Quantum with no problems. Perhaps that's just coincidence. Any suggestions?
(I reset the wah block to default and attached the preset in the event anyone wants to take a look)
Thanks,
Joe
I'm in the process of updating my presets to Quantum v1.01. I've got one preset with the Shiver Clean amp that works fine until I engage the wah block. To start with, I've got the amp settings on the patch tipping the output meters at about 0.0 dB. But when I engage the wah block, the higher frequencies send it off the chart into clipping territory. The level on the wah block is at 0.0 dB. When I listen to the preset through my monitors, I don't hear any significant volume difference with the wah block engaged or not. I've tried dialing back the 'Frequency Max' setting in the wah block. It helps a little but loses its tone when adjusting it enough to help with the clipping. Presently I'm using the 'Clyde' model but I've tried all the others with similar results. I used this same setup in my patches prior to Quantum with no problems. Perhaps that's just coincidence. Any suggestions?
(I reset the wah block to default and attached the preset in the event anyone wants to take a look)
Thanks,
Joe
Attachments
Last edited: