7 Stringer
Member
Hi there, first post!!!! Been lurking for a while though.Just got an AXE3 couple days ago to replace my G System for effects only in a wdw setup. Will be using the amp modeling too, eventually!!!!!
Ok, i am trying to mix in some dry tone in my wet cabs. I was using a separate mixer before with my G System but want to ditch that, a lot of cables!!!!
Tried input 4 mono - output 4 stereo to my stereo power amp. Could not get any dry at all, tried mixes at 100% in my effects blocks, tried putting a mixer block in middle row with all effects in parallel and summed back to the mixer.
Tried input 1 - output 1 stereo to my power amp.
Kinda works but i feel i might have phase issues. My wet cabs sound thin.
Signal goes like this: line out from a Suhr Iso out to input of Axe3. Then like i mentioned, out to my power amp.
Will i be able to achieve my goal with the Axe and no mixer? What would be the best way?
Thanks a lot.
Chris
Ok, i am trying to mix in some dry tone in my wet cabs. I was using a separate mixer before with my G System but want to ditch that, a lot of cables!!!!
Tried input 4 mono - output 4 stereo to my stereo power amp. Could not get any dry at all, tried mixes at 100% in my effects blocks, tried putting a mixer block in middle row with all effects in parallel and summed back to the mixer.
Tried input 1 - output 1 stereo to my power amp.
Kinda works but i feel i might have phase issues. My wet cabs sound thin.
Signal goes like this: line out from a Suhr Iso out to input of Axe3. Then like i mentioned, out to my power amp.
Will i be able to achieve my goal with the Axe and no mixer? What would be the best way?
Thanks a lot.
Chris