gatkins10
Member
I am using preset 125 from the Bank A of v15.x , Dual Clean. I added a Volume/Pan block after the speakers, like I do for every patch. However this time, the volume pedal works once, then it doesnt work again until I change patches and go back to preset 125. Up or down, it's on. Halfway, the volume is at 50%, it's almost like it's in pan mode, not volume. And after the first use of the pedal, the Edit light comes on, as if I was editing the patch. But all I did was use the volume pedal. All other patches I have modified are fine. It's only this one. Wondering what I did wrong????? running v15.03 on FxII. My volume pedal is a Mission into MFC-101 Mark II controller.
Ideas?
Ideas?
Last edited by a moderator: