There are a couple of 'Global' volume controls that can be controlled through Midi CC commands and/or the 'External Pedals'. In the 'I/O' menu, 'CTRL' tab.
I chose to do this on a per-preset basis. More initial work, but lets me control the volume at the optimal point (or points) in the signal chain.
- In 1 (manipulates the volume at the input, which changes the gain on higher gain presets as you reduce volume, similar to using the guitar volume knob - not very linear from one preset to another )
- Out 1 (manipulates the volume at the output, which cuts off any Reverb and/or Delay trails)
- Out 2 - FX Send (manipulates the volume at the output, which cuts off any Reverb and/or Delay trails)
Using AX8-Edit, you can 'copy' the block (and it's attached controller assignment) and 'paste' it into the other presets. Or save the block into the 'Block Library', then add that block to each preset.
Same here. I chose to attach the pedal to the CAB block, which I always place after the AMP and before things like delay and reverb. That way I don't have to have an extra block in the chain.I chose to do this on a per-preset basis. More initial work, but lets me control the volume at the optimal point (or points) in the signal chain.
for those wanting to do this, be sure to set the MIN and MAX values in your modifier screen - specifically you probably want your Max at 0 dB, NOT the +20 that it can give.Same here. I chose to attach the pedal to the CAB block, which I always place after the AMP and before things like delay and reverb. That way I don't have to have an extra block in the chain.
sounds like something in the pedal is traveling too much, rather than a setting. i'd contact support.fractalaudio.com and submit a ticket.I'm probably doing something silly but I'd appreciate any tips - my ev1 is controlling the volume fine apart from when the pedal is totally heel down it jumps back to full volume. Move it up a tiny bit and it's at zero and sweeps through to full volume at toe down. It appears to be calibrated ok, is there setting I'm missing?
I'm probably doing something silly but I'd appreciate any tips - my ev1 is controlling the volume fine apart from when the pedal is totally heel down it jumps back to full volume. Move it up a tiny bit and it's at zero and sweeps through to full volume at toe down. It appears to be calibrated ok, is there setting I'm missing?
ahh yes. you'd be looking for Auto-Engage in the Modifier menu (right click on the parameter you're controlling).Or if applicable, check your auto-off settings in the modifier