iaresee said:Make sure the SysEX ID of the unit hasn't changed. Make sure the unit is still listening for messages on the channel your DMC pedal is transmitting on.
Obvious question time: did you power cycle all the components?Belt said:iaresee said:Make sure the SysEX ID of the unit hasn't changed. Make sure the unit is still listening for messages on the channel your DMC pedal is transmitting on.
The sysex on the Axe hasn't changed. I checked the channel, and tried 3 others.
It still isn't communicating.
Should I load 9.0 again, and see if it works? Or would that not make a difference?
Belt said:I don't know what power cycling is.
So I probably didn't.
iaresee said:Did you try another cable? Try it with another controller or with your computer MIDI interface at home? Did you try plugging the DMC into your computer interface and using something that shows all the MIDI messages on the line to see if the DMC is actually sending data?
iaresee said:Did you try another cable? Try it with another controller or with your computer MIDI interface at home? Did you try plugging the DMC into your computer interface and using something that shows all the MIDI messages on the line to see if the DMC is actually sending data?
Try this:Belt said:iaresee said:Did you try another cable? Try it with another controller or with your computer MIDI interface at home? Did you try plugging the DMC into your computer interface and using something that shows all the MIDI messages on the line to see if the DMC is actually sending data?
I haven't tried another cable. As far as my midi interface, I have a midisport 4x4. I haven't figured out how to get the controller and the Axe Fx to connect to it, and change presets through the interface.
Through AxeEDIT, I can change via the midisport. But not DMC - Midisport - AXE.
I'll check another midi cable.