tonematch AFD100 if its already in the axe

[boardwlk17]

Should I tone match my AFD100 before I sell it? Isn't it in the Axefx2 already? Or should I tonematch it. Post Away!

 

[Morphosis]

You should A/B them using the same Cab (or IR from a cab) and tweak minor differences (if heard) in the advanced Parameters, beginning with the speaker tab, because there are the only parameters, which Cliff have to assume (which cabinet/speaker is interacting with the Amp). No tonematch needed IMHO. I tweak my Koch Studiotone into the Axe-Fx w/o Tonematching:

Camparison here: http://forum.fractalaudio.com/axe-f...ematching-your-real-amp-if-you-can-tweak.html

 

[yek]

AFD is in the Axe-Fx (Brit Super). Its #34 mode isn't modeled though.

AMP (block): list - Axe-Fx II Wiki

 

[tpruitt]

Can you capture an ir of your cabinet then tone match from the amps fx loop?
That way we can chose different ir's or even run the patches through a real cabinet!

 

[boardwlk17]

Maybe I'll do the #34 thanks I haven't touched it in monthes:lol

 

[boardwlk17]

So you just set up your Koch and your axe patch then adjusted the axe til it sounded closer?

 

[Morphosis]

So you just set up your Koch and your axe patch then adjusted the axe til it sounded closer?

That! But closer? I think it`s damn close! http://forum.fractalaudio.com/axe-f...ematching-your-real-amp-if-you-can-tweak.html No?