Chang Soo Ko
New Member
I would like to separate the POWER AMP Section separately from the AX8 AMP Section.
because when AX8 is used with REAL POWER AMP, POWER AMP(and Cabinet simulations) are not required.
but If it is connected with PA, POWER AMP(and Cabinet simulations) are must be required.
If PRE and POWER are separated,
Using FX LOOP connect to the REAL Amp's Return jack(only use PRE AMP on AX8's amp sections),
and OUTPUT connect to the PA(use PRE, POWER and cabinet sections).
because when AX8 is used with REAL POWER AMP, POWER AMP(and Cabinet simulations) are not required.
but If it is connected with PA, POWER AMP(and Cabinet simulations) are must be required.
If PRE and POWER are separated,
Using FX LOOP connect to the REAL Amp's Return jack(only use PRE AMP on AX8's amp sections),
and OUTPUT connect to the PA(use PRE, POWER and cabinet sections).