|| Tap/Hold functions and LEDs idea ||

J

Joshua Benton

Member
Currently, when you have a switch with both tap and hold functions, the LED does not do the best job of indicating what is happening with effects when using that switch. For example: the LED ring can be darkened or off even though an effect tied to that switch is on.

How about this:

Have a selection for programing the FC's that allows for only half the LED ring to illuminate. When you engage the tap function, only the top half is illuminated. When you engage the hold function, the bottom half illuminates.

This way you can have a better, real time understanding of what is going on with your preset.

Thoughts?
 
There's no "half", unfortunately... The ring is a single unit.

Also, I would amend your comments by saying that the issue you have is only about the Hold functions. The LEDs do a great job of indicating the state of the Tap functions, which is how the FCs were designed.

The FCs have been around for a while and a number of proposals have been presented for other options regarding Hold functions, but so far no bites.
 
unix-guy said:
There's no "half", unfortunately... The ring is a single unit.

Also, I would amend your comments by saying that the issue you have is only about the Hold functions. The LEDs do a great job of indicating the state of the Tap functions, which is how the FCs were designed.

The FCs have been around for a while and a number of proposals have been presented for other options regarding Hold functions, but so far no bites.
Click to expand...
appreciate your opinion
 
You must log in or register to reply here.
Back
Top Bottom