Check the front panel, I found some issues with the editing of values from axeedit3Set to Momentary and programmed only one value to be send- unfortunately no change.
Ok they look good. Can you setup a separate button. With only the CS assigned to the tap function with momentary.
And the midi messages?Did so. Display shows Control Switch 1 On/Off at Press/Release.
Ok, but only one midi message?On a first try nothing happens at Press/release. At a second try Midi is triggered at Press and Release. Next time no trigger on both, than again on Press and release. Very strange.
FC FW?Ok, but only one midi message?
I was thinking as much. Does onsong do some sort of midi thru, in a software sense?Both sides are working correctly if not linked. When both are activated the confusion starts. I don`t know how to solve this issue. Eventually there is a mismatch between the presets on the axe and the song positions in onsong creating a strange kind of loop. Nevertheless, that would be strange, because both sides, Axe and Onsong, make a correct preset/song selection on the respective other device, meaning the midi adressing is correct.
I was thinking as much. Does onsong do some sort of midi thru, in a software sense?