Hi everyone,
I am running an AxeFx 2 with a mesa 50/50 power amp into two 2x12 cabs.
While it sounds good I seem to have lost some 'tightness' and bottom end. I also think I am hearing some very minor modulation when I let notes ring out.
I have gone through the IO menu and made sure everything is set to stereo. I have also tried a number of different patches and seem to get the same thing.
Could this be phasing? Are my cabs too far apart (currently about 4ft)? Do I need to do anything in particular or is there any setup or tricks that I should know about? I did some searching online but cannot seem to find much real experience with stereo setup so I thought I would throw up a post and ask the question.
I am running an AxeFx 2 with a mesa 50/50 power amp into two 2x12 cabs.
While it sounds good I seem to have lost some 'tightness' and bottom end. I also think I am hearing some very minor modulation when I let notes ring out.
I have gone through the IO menu and made sure everything is set to stereo. I have also tried a number of different patches and seem to get the same thing.
Could this be phasing? Are my cabs too far apart (currently about 4ft)? Do I need to do anything in particular or is there any setup or tricks that I should know about? I did some searching online but cannot seem to find much real experience with stereo setup so I thought I would throw up a post and ask the question.
