So last night and this morning, I set up a 5150 on a 1960AV and the AFXIII/CA-9 on a second 1960AV and used a pedal to switch between between them. No deep editing on the Fractal, just adjusting the typical controls other than setting the impedance curve to the Bogner 4x12 curve. The cabs sound slightly different and I was switching them back and forth and got both rigs sounding very very similar etc etc.
Then I had both running simultaneously. I immediately could hear the sound was thicker and maybe overall louder, but I could only perceive sound coming from the 5150/cab. To equally perceive sound from the AFX/cab, I had to turn it up.
But then when I went back to listening to them in isolation, the AFX/cab seemed much louder than the 5150/cab.
I switch cabs between the rigs and it was the same thing. What might cause this?
Then I had both running simultaneously. I immediately could hear the sound was thicker and maybe overall louder, but I could only perceive sound coming from the 5150/cab. To equally perceive sound from the AFX/cab, I had to turn it up.
But then when I went back to listening to them in isolation, the AFX/cab seemed much louder than the 5150/cab.
I switch cabs between the rigs and it was the same thing. What might cause this?
Last edited: