Hi all, I have another question for you. I have been working with a/b swithching with clean & dirty amps. I have some patches that transition well and others that will give an audible "pop" when I switch. I have played around with them in series or paralell and have moved the order in which they are in series , but cant seem to get away from that pop....unless I mute the strings then it doesnt make the pop. Like I said before it doesnt do it with all patches , but a few of them it does and I cant figure out why. I have even tried to use a foot pedal instead of a switch but once I pass the 50% mark in the control grid it still does it. I have tried it really slow and fast with the pedal and it is still the same. Once it hits the half way mark the amps switch and the pop occurs. Is there a fool proof way to fix this and get a really smooth transition between amp models? I have seen some of the posts about this on yeks forum , but still havent been able to figure it out. I have seen on here also where people can fade the amps in and out smoothly with the transitions. Actually that is what I am trying to do.