Sleestak
Power User
Greetings. I'm adding an outboard effect pedal (Digitech Freqout) to my AxeFX III. I'm attempting to use Out3 as the source for the pedal. I can see in Axe-Edit that signal is present in the Out3 block, but nothing is actually being sent to my pedal.
- The pedal works. When I plug directly into it, and run the output into the front input of the AxeFX, it functions normally.
- When I connect the AxeFX Out3 to the pedal input, and pedal output to AxeFX In3, there is no signal being sent to the pedal.
- I can verify that the AxeFX In3 works normally. If I plug my guitar directly into the pedal's input jack, it sends signal to the AxeFX In3 block.
- It's not the cable(s). I have tested and swapped the cables with other, known to be good cables.