Thanks yek, yes I noticed this came through I've been using them successfully in my new MFC firmware.
New MFC firmware?
were the options implemented ? as per original request? aka none/all/tuner/tempoImplemented.
But the options weren’t? Just on and off? Cliff said (somewhere) that it was possible to just have tuner and not tempo.IIRC.At the time of posting Realtime Sysex was not implemented. It is now. That explains the label.
Ah so you are talking about a controller not the actual unit? I’m asking wether the unit can turn off the real-time messages... so that only tempo or tune are sent by the III.Your MFC doesn't to use both. Not sure which MFC you have or whether it has options. My firmware can use either independently.
Its just a waste of serial bandwidth if it's not needed. And also needless decode computing at remote end if the controller doesn't use that message (at all)... its not a biggy. ;-)Sorry - left a word out of my post, now corrected. What I'm saying is that the Axe-FX III can send both tuner and tempo information or neither. I'm surprised needing to have it send one without the other would be a problem, unless you have a MFC that has some undesirable display using information you don't want.