What firmware are you running?Experienced Axe FX user here. Just have a question about one of my presets. The left side is much louder. Can't figure out why. Thanks!
Preset attached.
There should be no natural balance issue.The most recent, I believe. 2.02? Thanks Joe.
Ok, looked at your preset. The issue is the Modern Enhancer you are using. The WIDTH is set to 0%, and this is causing a majority of the "enhanced" frequencies to pan left. Try starting with your WIDTH at 50%. Here is a description of the Modern ENHANCER block from page 66 of the AxeFX manual:Can you check the preset?
If you are running mono, just run Left only. Don't even run a cable out of the Right output. As for using the enhancer, I probably wouldn't. But, audio is subjective, and there are no rules. If it contributes something to your sound in an appealing way, then go for it. Some of my Best (and WORST) effect usage have been accidents.Is it something that is even necessary for mono presets?