ecalcagnino
Member
Hey all. The answer to my issue is likely somewhere, but I haven't found it. That's probably due more to the fact that I am not 100% how to ask, so please bear with me.
This is all using the AFX as the only interface connected to studio monitors at OUTPUT 1. I’m using Windows 10 with Studio One 3.2.
What I want to do: I would like to control the incoming USB volume separately from the AFX INSTR INPUT volume (front) using the two output levels on the front of the AFX. Let’s say OUT LVL 1 for direct guitar, OUT LVL 2 for USB.
How it works now: When I am recording and have a track armed with input monitoring off, I am monitoring my guitar direct through the AFX as well as the incoming USB playback from the DAW. This is how I would like it to work so this is fine. BUT, a lot of times my guitar is louder than I would like it to be and I can’t figure out how to adjust the USB volume separately from the signal I am recording. It seems like if I use any of the outputs to adjust the guitar volume by itself, it's changing the signal gain going into the DAW which I do not want to do.
Make sense? Did I leave anything out? Thank you for your help, this is driving me nuts.
Eric
This is all using the AFX as the only interface connected to studio monitors at OUTPUT 1. I’m using Windows 10 with Studio One 3.2.
What I want to do: I would like to control the incoming USB volume separately from the AFX INSTR INPUT volume (front) using the two output levels on the front of the AFX. Let’s say OUT LVL 1 for direct guitar, OUT LVL 2 for USB.
How it works now: When I am recording and have a track armed with input monitoring off, I am monitoring my guitar direct through the AFX as well as the incoming USB playback from the DAW. This is how I would like it to work so this is fine. BUT, a lot of times my guitar is louder than I would like it to be and I can’t figure out how to adjust the USB volume separately from the signal I am recording. It seems like if I use any of the outputs to adjust the guitar volume by itself, it's changing the signal gain going into the DAW which I do not want to do.
Make sense? Did I leave anything out? Thank you for your help, this is driving me nuts.
Eric