TG3K
Fractal Fanatic
I recently set the Bank Size to zero on my MFC, so now I use the Up and Down switches to scroll through my presets. I have noticed some strange behavior with the MFC since I made the change. If I try to step through the presets quickly with single pushes of the Up or Down switches, the MFC doesn't stop where I stop. It jumps back a preset or two. In other words, if I tap quickly through 001, 002, 003, 004, 005, 006, when I stop, it'll jump back to 005 or 004. Similarly, if I hold down the Up or Down switch so the MFC can cycle through the numbers quickly, it'll jump back a big chunk of numbers. For example, I can hold the Down switch on 025 and watch the display go down sequentially from 025 to 005 or so, but when I take my foot off the switch, it'll jump back to 022 or some other random number. Has anyone seen similar behavior, or do you have any ideas what I might have set up wrong?
On a possibly related note, I've recently noticed that the MFC and Axe-Edit don't seem to talk to each other as well as they used to for me. In the past, if I hit a switch on the MFC (to turn on a chorus block, for example) while using Axe-Edit, I'd see the enabled block in Axe-Edit almost instantly. Lately though, it doesn't show up at all. I suspect there's a parameter on the MFC that I munged up somehow, but I have no idea what it might be. Any suggestions?
On a possibly related note, I've recently noticed that the MFC and Axe-Edit don't seem to talk to each other as well as they used to for me. In the past, if I hit a switch on the MFC (to turn on a chorus block, for example) while using Axe-Edit, I'd see the enabled block in Axe-Edit almost instantly. Lately though, it doesn't show up at all. I suspect there's a parameter on the MFC that I munged up somehow, but I have no idea what it might be. Any suggestions?