Nobels MF-1 MIDI Footcontroller

N

norbert

Member
Hello,
a question to the forum members: Is it possible to run the Nobels MF-1 MIDI Footcontroller with a 7pin cable to the Axe Standard? It would be the easiest power supply.
Norbert from Germany.
 
You still need a power supply connected on the power input on the rear panel, your Axe Standard will just pass on whatever you connect there. DISCLAIMER: it´s up to YOU to have the correct voltage, ampere and polarity on your power supply, otherwise you may damage your MIDI controller. No one on this forum can be held responsible for what you´re connecting in the power jack at your Axe Standard.

However, it´s just not that simple with your MF-1. Since it only got 5pin DIN connectors, you will have to have a 7pin - 5pin cable (aka custom/home made). Hence the above disclaimer...

/Mike
 
You must log in or register to reply here.
Back
Top Bottom