No function after firmware update

scotts

scotts

Inspired
I just updated the MFC firmware. The update was successful. Whether I power on the MFC with the wall wart or through the Axe II via cable the MFC does not respond to any button presses. Button 1 red light is on. "Up" & "Down" lights are green.
???
 
If you came from firmware version < 1.0, after upgrading you have to do a factory restore by rebooting with the #11 footswitch held down.
 
Thanks volt. I just found that in the "Read Me". Hmmm... they call it "Read Me" because I'm supposed to READ it.
 
My dad's favorite phrase was "If all else fails, read the instructions".
Works for most "life" situations... LOL
 
You must log in or register to reply here.
Back
Top Bottom