New issue trying to install firmware

[mngolf]

This is a new issue. In the middle of a firmware update (X% complete), FractalBot will put up an error message that says "no response received." The device is connected, but for some reason, it seems that it loses the connection midway through the update. I am using a Mac and this has always worked with no issues.

Any ideas?

 

[Brucegregori]

If you have AX Edit opened close it and restart your AXE Fx and FractalBot and try it again. It took me a few try's and then it went ok.

 

[mngolf]

If you have AX Edit opened close it and restart your AXE Fx and FractalBot and try it again. It took me a few try's and then it went ok.

Tried that with no luck. It gets to X% and then disconnect. Argh.

 

[mr_fender]

Try switching to an empty preset before using Fractal Bot. That leaves the most resources available for it. Audio processing always takes precedence. If you have a high CPU preset loaded, it can bog those operations down quite a bit and sometimes cause timeouts and errors.

 

[biskitboy]

Are you on an empty preset? If not, try it.

 

[Jan Geerts]

Had that too. Tried it on another computer and that worked.
Tried closing axe edit, with no result. Never had this issue before

 

[mngolf]

Are you on an empty preset? If not, try it.

I am

 

[FractalAudio]

Install latest version of FractalBot.

 

[mngolf]

It finally worked!

 

[Brucegregori]

Great. Yeah it did take me a few times. That is not usually the case.

 

[Jan Geerts]

Install latest version of FractalBot.

Did that. Still didn´t work on my laptop