Party Pooper
Member
Hi All,
I hope what I did can be reversed.
I understood that there was a firmware update for the FC-12 1.06. I looked at the Fractal download section and the newest update was 1.05, which I have. So I searched Fractal Firmware 1.06 and there it was. I downloaded it and installed. The problem was that it was firmware1.06 for the Axe FX 3, not the FC 12.
I downloaded and installed the correct Firmware 5.07 and then found and installed the correct FC-12 1.06 firmware. Both units display the correct firmware and the Axe FX3 appears to be working correctly however the same cannot be said for the FC-12. On power up, the scribble strips are blank but the correct preset is displayed in the top window. If I hold button 6 and press the 8 button (I do this to go to the "scenes" layout on the number 2 button, but now I get "layout 1", "layout 2", etc.. not what I usually see. No matter which of these "layout" buttons are pressed, there is no result.
I'm hoping there is a fix for this.
Please help!!!!!!!
I hope what I did can be reversed.
I understood that there was a firmware update for the FC-12 1.06. I looked at the Fractal download section and the newest update was 1.05, which I have. So I searched Fractal Firmware 1.06 and there it was. I downloaded it and installed. The problem was that it was firmware1.06 for the Axe FX 3, not the FC 12.
I downloaded and installed the correct Firmware 5.07 and then found and installed the correct FC-12 1.06 firmware. Both units display the correct firmware and the Axe FX3 appears to be working correctly however the same cannot be said for the FC-12. On power up, the scribble strips are blank but the correct preset is displayed in the top window. If I hold button 6 and press the 8 button (I do this to go to the "scenes" layout on the number 2 button, but now I get "layout 1", "layout 2", etc.. not what I usually see. No matter which of these "layout" buttons are pressed, there is no result.
I'm hoping there is a fix for this.
Please help!!!!!!!