Hello Everyone -
I have a patch that splits off after the Amp Block to a GEQ and then FX Loop. I have the 2 FX Loop sends connected to channels of the power amp (Fryette 2/90/2) with each output connected to a dedicated cab.
I only get output on 1 of the channels. Is there something I need to be doing to ensure this is stereo going out through the FX Loop? Balance is set right at 0.
Thanks very much,
Dan
I have a patch that splits off after the Amp Block to a GEQ and then FX Loop. I have the 2 FX Loop sends connected to channels of the power amp (Fryette 2/90/2) with each output connected to a dedicated cab.
I only get output on 1 of the channels. Is there something I need to be doing to ensure this is stereo going out through the FX Loop? Balance is set right at 0.
Thanks very much,
Dan