GuitarAng3l
Member
I finally got a real cabinet and a power amp and trying to fit my signal chain to it.
Normally I run just a simple amp + reverb chains but sometimes I need some ambient / wet solo tones which I archieve with the stereo chorus or some delays.
I run just 1 IR in the center, thats it. When only the reverb is on, it sounds like the guitar sits in the middle, when I add the wet effects it gets wider.
Now with the real cab, I placed the cab block after all the effects and hard panned the same IR L/R. But now my "dry" tone with just reverb is wide too. Is there a way around this?
Otherwise how do I sum the delay and chrous up to mono?
EDIT: What about the Stereo Spread? When I set up a patch in mono, it should be at zero right?
Normally I run just a simple amp + reverb chains but sometimes I need some ambient / wet solo tones which I archieve with the stereo chorus or some delays.
I run just 1 IR in the center, thats it. When only the reverb is on, it sounds like the guitar sits in the middle, when I add the wet effects it gets wider.
Now with the real cab, I placed the cab block after all the effects and hard panned the same IR L/R. But now my "dry" tone with just reverb is wide too. Is there a way around this?
Otherwise how do I sum the delay and chrous up to mono?
EDIT: What about the Stereo Spread? When I set up a patch in mono, it should be at zero right?
Last edited: