greiswig
Power User
I've had strange panning issues for awhile now, but recently I set up a preset that uses an enhancer block late in the chain, and it made it worse. It actually does shift the stereo image from center, too. Here's the scenario:
Kitchen sink presets, often using two IR's panned left and right respectively. Add a reverb. All centered.
Almost invariably, the output meters on Output 1 show a higher level on the left channel. Then if you engage the enhancer, that distinction is made much worse...by about 3dB according to my metering. Here's the other thing: it doesn't matter whether you have the IR's panned hard L-R or centered. In fact, you can pan them the other way (R-L) and the Left channel will still be metering higher. Same thing even if you bypass the reverb, the only stereo effect present.
I've attached a preset that demonstrates it.
Any idea what's going on here?
Kitchen sink presets, often using two IR's panned left and right respectively. Add a reverb. All centered.
Almost invariably, the output meters on Output 1 show a higher level on the left channel. Then if you engage the enhancer, that distinction is made much worse...by about 3dB according to my metering. Here's the other thing: it doesn't matter whether you have the IR's panned hard L-R or centered. In fact, you can pan them the other way (R-L) and the Left channel will still be metering higher. Same thing even if you bypass the reverb, the only stereo effect present.
I've attached a preset that demonstrates it.
Any idea what's going on here?