sprint
Axe-Master
This subject was discussed somewhere on the forum before but I can't seem to locate it now.
In Axefx3 if I take two cables and connect them directly from output2 (xlr) to input 2 (1/4") I notice the signal is about 4db hotter after Loop2 (Output2 Block > Input2 Block) than before it. Is this because of the balanced out?, or does output 2 (or input2) increase volume (I thought it should be equal with output2 config set to -10dBv/Phase=Normal/CopyOut1=Off, Input2/output2 set to STEREO, all block levels set to 0, and physical output knobs all set to max)
In Axefx3 if I take two cables and connect them directly from output2 (xlr) to input 2 (1/4") I notice the signal is about 4db hotter after Loop2 (Output2 Block > Input2 Block) than before it. Is this because of the balanced out?, or does output 2 (or input2) increase volume (I thought it should be equal with output2 config set to -10dBv/Phase=Normal/CopyOut1=Off, Input2/output2 set to STEREO, all block levels set to 0, and physical output knobs all set to max)
