LanceZ
Inspired
I'd appreciate some words of wisdom from anyone who is using the Roland FC-300 with the Axe-Fx, and using "patch mode" to successfully send patch changes to the Axe-Fx. I've had zero success.
Simple: I want to select Axe-Fx patch 212 by pressing FC-300 "patch mode" patch P.001 with my foot. I want to select some other Axe-Fx patch by pressing FC-300 patch P.002, etc.
Here's what I tried:
* I edited a "MIDI stream" in patch mode
* where message 01 was CC#0 (Bank Select Course) value #001 (Bank B)
* and message 02 was CC#32 (Bank Select Fine) value #044 (patch 212)
* Then I followed the instructions on FC-300 manual page 44 for saving this to a patch (P.001).
* After this, when I select away from then back to P.001 on the FC-300, nothing happens on the Axe-Fx.
* When I switch the FC-300 back to Standard Mode, it changes patches 1-128 no problem.
I'm really frustrated. :evil: Any help is super greatly appreciated.
Thanks,
Lance
Simple: I want to select Axe-Fx patch 212 by pressing FC-300 "patch mode" patch P.001 with my foot. I want to select some other Axe-Fx patch by pressing FC-300 patch P.002, etc.
Here's what I tried:
* I edited a "MIDI stream" in patch mode
* where message 01 was CC#0 (Bank Select Course) value #001 (Bank B)
* and message 02 was CC#32 (Bank Select Fine) value #044 (patch 212)
* Then I followed the instructions on FC-300 manual page 44 for saving this to a patch (P.001).
* After this, when I select away from then back to P.001 on the FC-300, nothing happens on the Axe-Fx.
* When I switch the FC-300 back to Standard Mode, it changes patches 1-128 no problem.
I'm really frustrated. :evil: Any help is super greatly appreciated.
Thanks,
Lance