Thanks man. I've just seen your reply now.I do just this kind of thing for a living.
But I can't refuse a good challenge every now and then. This one is on the house..
I would raise the 'Low Cut' in the Cab block, Preamp Tab, a bit higher (125-150 Hz?), too much low-end IMHO.
- Cabs in User Bank 1, Slots #48 and #49 (see pic below)
- Used a different model that was closer to my ear (ODS-100 Ford PAB).
- Tweaked the two Amps, and Cab block by ear. (a live Tone Match would make it REALLY close)
- Reset and matched the Drives, Compressor, Delay and Reverb.
- Reset the 'Clyde' Wah to Factory defaults.
- For 'Cygnus' 16.05
View attachment 88522
Turn up the volume (Level) to the desired degree.the volume drops down drastically.
Did I do something wrong?
Exactly that. For the D30 I mainly use, copying the axe FX II settings seemed a good start but in the end turned out to be a dead end road and a considerable loss of time. Just spent one or two hours for starting at scratch and all should go well in the end.You'll have to use your ears and forget about replicating fx2 settings. Went through that phase also and it just like that.
Tone Matched IR's go through some sort of normalizing process when they are created. I typically set the cab block level to '5.00' dB when using them.I even tried to tonematch my II , comes even closer. But when I want to export it to a cab file the volume drops down drastically.
Did I do something wrong?
There are listed in my post, and also shown in the screenshot.Which cabs did you use?
Ah ok so you also used my self-created cab "OR-4x12 ... Multi Georg" ?There are listed in my post, and also shown in the screenshot.
Yes, it uses the same two cab IRs. My mistake. Yep, Cab #2 in the cab block should have been set to #59.Ah ok so you also used my self-created cab "OR-4x12 ... Multi Georg" ?
Just wondering 'cause you set it to user2 #49 whereas it should be on #59