FX PROCESSOR
Member
I get your situation . I only need to run a fuzz pedal. I'm going to insert in parallel a 9volt supply into the power cord near the fm3. Some soldering and box making (plastic) will be required . "One spots" are pretty small with the case removed . As alway's, if your not up to the task (dangers) of doing the job. Find some one you trust your life to, to do it for you, or just don't . But this route might be safer for the fm3 ,and possibly better filtering from a professional supply. The FM3 just cost too much for me to go fiddling with it. Good luck.I only have one additional pedal on my board - an additional power supply only for one single pedal is really annoying ...
Last edited: