Holdsworth patches v7

Love the Holdsworth tone and you did a great job nailing it. Your playing is very nice too. Thank you so much for sharing this. Where is the tone stack located? In the amp module?
 
I downloaded the tones but when i load them in axe edit, they wont make any sound? Is it because i don't have the same cabinets installed as you?
IS it because my Axe Software a different version?
I really want to try these patches on my STEINBERGER :)
 
phantomofalfred said:
I downloaded the tones but when i load them in axe edit, they wont make any sound? Is it because i don't have the same cabinets installed as you?
IS it because my Axe Software a different version?
I really want to try these patches on my STEINBERGER :)
Click to expand...

Assuming you haven't seen the 100,000 posts on AxeEdit not being compatible with FW 9 :) Don't use it until the new version is out ... it's coming!
 
Phantom - the volume block is tied to external 1. If you font have a pedal assigned to external 1, then just shunt the volume block.
 
Also remember to back off your guitar volume a touch and roll off the tone until it starts to attenuate the high frequencies.
 
You must log in or register to reply here.
Back
Top Bottom