High gain patches now squealing with 14.02 update [NOT A BUG]

D

davieb

New Member
Just updated to firmware 14.02 from 12.02 and many of my high gain patches are now squealing.
Got to reduce the master output knob quite a bit to help eliminate the feedback.
I was previously running the output 1 on full
Most of my gain patches use the vox and marshall amp blocks with a treble booster before the amp block.
AXE FX2 is plugged straight into my mixing desk and monitored through studio speakers.
Went back to 12.02 and the squealing is gone.
Really want to use the latest firmware for the new features etc.
Anyone any ideas?

Thanks in advance.
 
Last edited by a moderator:
This happens to folks that get too excited over 14.02.......so.......Stop sticking your d**k in the rear input & the squealing will stop!
 
Thanks for the quick reply,most patches now ok with recommended settings re:release notes.
Great to finally have the Tri-Axis LD1 Red mode, didn't read anything past that:)
Cheers!
 
FractalAudio said:
Read the release notes, especially the part about the Global Noise Gate Offset.
Click to expand...
After reinstalling 14.02, my global noisegate offset automatically set itself to 0.00 db, only the first time I downloaded the fw did I ever see the -40.00 db? 14.02 still shows a dynamics control too, which I thought was removed from the amp block with this fw?
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom